03 Toyota Tundra 4.7 Water Pump Replacement

Shop Our Pumps Online.

03 toyota tundra 4.7 water pump replacement. Apply soapy water to the O-ring. Discussion Starter 1 Jun 7 2012. The sealant around the water inlet housing should be a 18 wide bead.

Is it possible to remove the upper plenum not the lower and pull the pipe out of the pump and replace the o-ring without removing the timing belt. Water Pump Sprocket Tool. Related repairs may also be needed.

I did the following maintenance items. Hi I have a 2006 47L Tundra. If you have just replaced your Timing Belt on your 2UZ-FE engine Tundra Sequoia 4Runner LandCruiser and you have a No Start condition assuming the timing is correct.

This range does not include taxes and fees and does not factor in your specific model year or unique location. Shop Our Pumps Online. I have a 2002 tundra with the 47 V8 just recently replaced the water pump and timing belt gates kit due to my water pump leaking 195k on the truck so got it all back together it ran fine for about a week and a half then noticed it leaking fluid again couldnt tell from exactly but figured it was from the thermostat housing area because there was fluid pooling up around the top of the intake and I could see a fresh source of it on the top of the water pump.

This truck is a 2005 Tundra but should be very close t. I would replace it and I did that on my Timing Belt project on former Tundra the Key issues are water pump failures do happen and since your allready there you might as well since its a preventive item. - replace water pump - replace idler tensioners belts timing and serp - full timing belt replacement - any pulleys with bearings Tested engine and she fired up great but we have a.

Water Inlet Housing Mates to Using Toyota Seal Packing 08826-00100 or Equivalent. Connect the water pump to the water bypass pipe end. We Deliver Water Pumps Direct to You Anywhere in Australia.