08 Toyota Tundra Code C1241

I checked the voltage the junction point 4 pin connector located just above the diff.

08 toyota tundra code c1241. The cost to diagnose the C1201 TOYOTA code is 10 hour of labor. Found broken wires in the harness. If there is a problem with the brake actuator assembly Skid Control Electronic Control Unit power supply circuit the skid control ECU outputs the Diagnostic Trouble Code DTC and prohibits under the fail safe function.

P0138 o2 sensor voltage high bank 1 sensor 2. C1241 low battery positive voltage or abnormally high battery positive charge. C1241 Toyota hybrid 2009.

A Turn the ignition switch off. - Stop light switch-check ok. Check engine light and all the other lights are on including 4wd.

When there is an abnormality in the power supply circuit of the brake actuator skid control ECU the skid control ECU sets a DTC and the operation is prohibited by the fail-safe function. If there is a problem with the brake actuator assembly Skid Control Electronic Control Unit power supply circuit the skid control ECU outputs the Diagnostic Trouble Code DTC and prohibits under the fail safe function. I replaced the left rear wheel sensor after verifying the voltage getting to it was 126V.

The code is a Low Battery Positive Voltage code. Most auto repair shops charge between 75 and 150 per hour. On my drive to work this morning I had Codes C1241 LOW BATTERY POSITIVE VOLTAGE OR ABNORMALLY HIGH BATTERY POSITIVE VOLTAGE and P0330 Knock Sensor 2 Circuit Bank 2 pop up.

They read C1201 c1223 c1241 c124. I started hearing a ticking noise only when accelerating and shortly after the check engine light came on. The techstream says High or Low Power Voltage.