2000 Toyota Tundra Accelerator Pedal Senor

Accelerator pedal position sensor is mounted on the throttle body and it has the 2 sensors to detects the accelerator position and a malfunction of the accelerator positions own.

2000 toyota tundra accelerator pedal senor. Please also check out the statistics and reliability analysis of the 2000 Toyota Tundra based on all problems reported for the 2000 Tundra. Hopefully a new Throttle PEDAL Position Sensor Toyota Part 78010-33010 PEDAL ASSY ACC will fix it. There are two redundant opposing sensors built into both the accelerator position sensor and the throttle position sensor.

Not sure if the throttle position sensor is the same as the accelerator pedal position sensor or not but thought I would let you know. 2000 Toyota Tundra 4X4 47L P1121-accelerator pedal position sensor. RockAuto ships auto parts and body parts from over 300 manufacturers to customers doors worldwide all at warehouse prices.

The TPS is on the drivers side and the APS is on the pass side of the throttle body. 2 Accelerator Pedal Sensor problem of the 2000 Toyota Tundra. So now I would recommend FIRST to replace the Throttle PEDAL Positon Sensor it is much much cheaper and then the Throttle BodyTPS assembly.

It is relatively serious problem since it can leave your vehicle in failsafe mode. It is located between the engines intake manifold and the air filter. 2000 toyota tundra has no throttle response during extreme cold.

Throttle Pedal Position Sensor Switch TPS A Circuit Range Performance Problem. If at any point the PCM detects an anomaly in either the TPS or APP voltage sweeps the system goes into limp mode and usually wont allow more than 25 throttle. Accelerator Pedal Sensor problems of the 2000 Toyota Tundra.

Three problems related to accelerator pedal sensor have been reported for the 2000 Toyota Tundra. ThrottlePedal Position SensorSwitch DE Voltage Correlation The PCM determines ETC motor operation based primarily on input from a pair of throttle position TP sensors mounted on the throttle body and a pair of accelerator pedal position APP sensors connected to the accelerator pedal. The accelerator pedal position sensor is connected with the accelerator pedal by the accelerator wire and the voltage applied to the terminals VPA and VPA2 of the Engine.