2000 Toyota Tundra Drive Cycle

Running through the drive cycle sets all the system monitors so that subsequent faults can be detected.

2000 toyota tundra drive cycle. An engine control unit ECU also commonly called an engine control module ECM is a type of electronic control unit that controls a series of actuators on an internal combustion engine to ensure optimal engine performance. The dealer will be able to perform the drive cycle on a. Otherwise you need to exercise each of the types of monitors.

My Toyota Tundra V8 had the passenger side exhaust manifold replace. 2000 TOYOTA TUNDRA 4-WHEEL DRIVE Slightly smaller than its rivals the Tundra is being sent to do battle with the full-sized pickups built by Ford GM and Dodge. MIL must be off.

Instructons to set the drive cycle for 2000 toyota tundra Customer Question. If there are pending malfunctions that have not yet turned on the malfunction light the monitors will not become ready. ToyotaLexus use a series of diferent drive traces for each system monitor.

You must park the vehicle in a heated garage above 40 F for 12 hours with the key off and fuel tank at 12 to run the evap monitor. If your smog technician tells you the specific drive cycle to perform you can focus on just triggering that drive cycle. The average cost for a Toyota Tundra OBDII drive cycle test is between 44 and 56.

Altitude is below 7801 feet 2400 m. IAT Intake Air Temperature must be above 13E F -10E C. The blower motor is located directly below the passanger glove box on the right.

Driving Procedure If IAT is less than 50E F 10EC at engine start-up idle engine for 10 minutes. The 2000 Toyota Tundra ECU is located above the gas pedal close to the steering column. I put new oxygen sensors both the front O2 and and rear O2.