2000 Toyota Tundra Starter Relay Removal

Remove the solenoid connection.

2000 toyota tundra starter relay removal. Theres also another issue where the ignition switch is used to power the starter solenoid through a relay on the manual or directly on an auto. Heres a bypass for those that dont have the starter relay on the wheel well. The easy way to replace the starter without removing any exhaust components or touching it.

I am not responsible for any damages that occur upon watching this video. I have checked the battery voltage starter relay. Slide the starter back and rotate the solenoid toward you.

Was the Starter Relay inside the engine fuse box and not the Starter of Starter Selinoid. How to remove the starter from a Toyota 47L V8 after removing the intake assembly and surrounding components. Twist the radiator cap one full turn pause for a.

Posted by Anonymous on Jun 24 2014. Sometimes starts right a way sometimes have to turn. Pull the wires away removing them from a metal clip on the frame.

Lift the relay required me to use a screwdriver to get under the relay and pry it upwards from different angles until it got loose enough to be pulled up by hand. Now you can twist the starter out and away from its mounting position. Disconnect all the bolts that hold the starter to the block using a ratchet.

1 disconnect battery 2 remove any wires connected to the starter 3 remove mounting bolts 4 catch the starter and manouver it through your suspincion 5 you may need to reverse 2 and 3 depending on how hard the wires are to get to 6 now revers these steps with new starter. 15 hours to remove and 45 minutes to replace. If the radiator is still warm allow it to cool off before you start next step.