2010 Toyota Tundra Oil Light Reset

Or follow the link above and see how.

2010 toyota tundra oil light reset. Press and hold trip meter reset knob and turn the ignition to the RUN position. With vehicle ignition switched to ON position make sure odometer is showing Tripmeter A then turn the ignition switch to OFF position. Resetting the ECU turns the indicator off and wipes out any codes the ECU may have.

Turn the ignition off. Hold knob for at least 5 seconds until 000000 is displayed and light turns off. Mk and Jason the light still comes on at 45005000 miles to remind you to perform all of the other maintenance required at that interval such as tire rotation fluid checks etc.

Push and hold down the ODO button and push the Power button twice with your foot off the brake. In the future you also can ask your Toyota dealer to reset the light after changing the oil. The oil change reminder indicator should be reset.

This is best done after any repair work to. Go to the Settings menu by using the navigation button. Oil Viscosity and Capacity The 4 liter engine holds approximately 48 quarts 45.

This is how you turn off the maintenance light on a Prius. The flashing dashboard light will go off and the reading on the odometer will reset. To reset the 2006 Toyota Tundra maintenance light please follow these instructions.

Turn the key to the on position accessories but not powering up the carPress the display button until you reach trip AContinue to hold while trip A is sele. Go down and select the VEHICLE SETTINGS. Youll see the odometer flashing 5 lines then 4 then 3 2 and 1 until all the lines are gone.